Asked by: Idali Pollmannasked in category: General Last Updated: 25th June, 2020
How do I remove crankshaft pulley?
Click to see full answer .
Keeping this in consideration, how do you remove a crank pulley without a puller?
There is a way to do it. You put a wrench on the pulley bolt and block the other end against the floor or the frame. Then you use the starter motor to turn the engine (DO NOT START IT, JUST TURN IT) for at most one or two revolutions of the crank . Just enough to break the bolt loose.
Also, how do I know if my crankshaft pulley is bad? Bad Crankshaft Pulley Symptoms
- 1) Engine Vibrations. The first symptom that will likely come up are engine vibrations.
- 2) Alternator Failure. The crankshaft pulley is responsible for powering the alternator.
- 3) Power Steering Pump Failure.
- 4) Transmission Damage.
- 5) Irregular Idle Engine Speed.
Also asked, what causes a crank pulley to wobble?
Perhaps when they were installed (or re-installed following service), some dirt was trapped under the pulley and/or they were torqued improperly, causing the wobble . With the fan-belt pulley removed you'll be able to examine the harmonic balancer more closely for damage.
Where is the crankshaft pulley located?
The crankshaft pulley is bolted to the harmonic balancer and turns the belt, or belts, to operate other engine components like the alternator or air conditioning compressor. It is located at the end of the crankshaft near the bottom of the engine.